Built Like Our Shelf Cases: Snap Hinge and Locking Latch on Every Custom Build
Hardware
Custom layout. Same tough hardware.
A custom case is not a lesser case. Every build gets the same print-in-place snap hinge and locking latch as our shelf cases, and bigger cases get a stronger hinge.
Build your case →Free to design · printed to order · final salePrint-in-place snap hinge
The hinge is printed as part of the case, so there are no pins to lose or screws to loosen. Larger custom cases automatically get our five-knuckle hinge for extra support along the back.
Single or dual latch
Every case closes with a locking latch. On cases 154 mm (6.1 in) and wider you can choose a dual latch for an even hold across the full width of the lid.
Printed on our own farm
Your case is printed to order on our own print farm in Las Vegas, with the same materials and settings as the cases we sell every day.
What you can choose
3 mL slots
17.5 mm pockets
For standard 3 mL vials up to 40 mm tall, including the cap.
10 mL slots
26 mm pockets
For 10 mL vials up to 55 mm tall. Mix both sizes in one case — the 3 mL pockets rise so every top lines up.
Storage bay
Optional
Add up to eight open bays for supplies like syringes or prep pads — pick a preset or enter your own size.
Latch & colour
Dual latch on cases 154 mm (6.1 in) and wider.
Frequently asked questions
Do custom cases have the same hinge and latch as shelf cases?
Yes. Every custom case uses the same print-in-place snap hinge and locking latch.
When can I choose a dual latch?
On cases 154 mm (6.1 in) and wider. The builder shows the option when your case is big enough.
Where are custom cases made?
Printed to order on our own print farm in Las Vegas.
More about building your own case
VialCase makes storage and organization cases only. We do not sell vial contents, and nothing on this page is medical advice.
Make your own case
Pick your 3 mL and 10 mL slots, add storage, choose a latch and colour, and see it live in 3D.
Open the Case Builder →